Mi-T-M Kerosene Portable Heaters Manual del operador descargar pdf (Pagina 11)

Kerosene Portable Heater Manual 11

Note: Tools required: medium phillips screw driver, open end or adjustable wrench, long nose pliers.

ASSEMBLING FRAME AND WHEELS

1. Slide axle through wheel support frame. Install wheel bushings, at washers (S) and wheel on axle.

NOTE: When installing wheels, tube valve should face out from support frame.

2. Place at washers (L) and cotter pins on axle ends and bend cotter pins with long nose pliers to secure.

3. Place wheel cap on at washers (L) and put wheel cap in at washers (L) end.

4. Place heater on wheel support frame. Make sure air inlet end (rear) of heater is over wheels. Align the holes

on fuel tank ange. Insert screws through handles (front and rear), fuel tank ange, and wheel support frame

as shown in below and attach nut nger tight after each screw is inserted.

5. After all screws are inserted, tighten nuts rmly.

DO NOT OPERATE HEATER WITHOUT SUPPORT FRAME FULLY ASSEMBLED TO TANK.

ASSEMblY

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Sin comentarios

Mi-T-M Kerosene Portable Heaters Manual del operador Pagina 11