
Propane Convection Heater Manual 11
ASSEMBLING THE HEATER
1. Remove heater from carton
2. Slide upper housing straight up and off of lower housing, and remove all
of the packed items from inside heater.
3. Remove all packaging protecting heater during shipping. Retain plastic
caps covering inlet and regulator hose for storage
4. Save carton and packing materials for later storage.
5. Inspect heater closely for any damage that may have occurred during
shipping. If there is any damage, return the heater to the place of
purchase.
6. Attach 4 (four) of the phillips head screws to the bottom row of holes in
the lower housing.
7. Slide upper housing over lower housing, lining up the four remaining screw
holes. Insert 4 (four) phillips head screws and tighten securely.
WANRING: NEVER ATTEMPT TO LIGHT A HEATER UNTIL IT IS FULLY ASSEMBLED.
CONNECTING TO GAS SUPPLY
IMPORTANT! Always use a propane cylinder that has a connection
device that is compatible with the hose and regulator assembly
supplied.
1. To connect hose and regulator assembly, rotate tting on hose/
regulator COUNTERCLOCKWISE into threads on tank valve (see
Figure 5). Be sure to tighten rmly.
Important: Be sure to position the regulator so that the regulator is horizon-
tal, also as shown .
2. To connect to heater inlet, rotate clockwise and tighten rmly with
a wrench.
3. Check all connections for leaks, using a 50/50 solution of dishsoap
and water. Bubbles at the connections show a leak. Correct all
leaks before lighting heater. NEVER USE AN OPEN FLAME TO
CHECK FOR LEAKS.
ASSEMblY
Phillips screws
Support Screws
in place
Regulator Hose
Assembly
Phillips and Support
Screws, Knob
Lower Shell
Gas Valve Stem
Phillips Screws
(use bottom holes)
Upper Shell
Supply Valve
Regulator
Hose
Propane Tank
Comentarios a estos manuales